Objects in extension pack missing details

Sep 30, 2011 at 11:16 AM

Hi,

Not sure if I am doing something wrong here, but all the objects included in the SCCM Extension IP are missing the details tab.

In so much that they do not have any object parameters and therefore can't accept inputs.

On other objects created by QIK I get three tabs (General, Details, Run Behavior) but on the object imported in this IP I get (General, Properties, Filters, Run Behavior) and all are blank.

I've checked that the DLLs have been imported and registered correctly (I am only using Opalis in my lab and so all roles are being performed by a single server).

Am I missing something here?

Regards,

Steve Carter.

Coordinator
Sep 30, 2011 at 2:25 PM
Edited Oct 10, 2011 at 10:25 PM
Hey Steve,
You need to setup a configuration (under options tab in the UI) then reference that configuration on the object you would like to use. 
Oct 11, 2011 at 1:19 PM

Hey Ryan,

 

Thanks, that was the problem. I've added in the configuration and it's looking good!

 

Regards,

Steve.